adahandmade · Studio reference
Custom Rug Specification Guide: Design, Sample and Approval
A custom rug develops through a room brief, a design drawing and a physical sample. The written specification keeps material, size and finish aligned with those approvals.
Start with the room and the furniture group
Send a plan or a measured sketch showing the furniture the rug has to relate to, the routes people walk, and the light sources that fall across the floor. Note whether the front legs or all legs of the seating sit on the rug. These layout decisions establish an initial outline that can be reviewed alongside the design.
Design and detail
State which design in the collection you are starting from, if any, and what has to change. Pattern scale, the direction of a carved line, the density of a motif and the treatment of the edge are separate decisions and are recorded separately. Where a design uses relief carving or a high-low cut-loop finish, say how the surface should read at the distance people will actually see it, from the doorway as well as from the sofa.
Size, colour and material are agreed, not assumed
A reference size in the catalogue is a starting figure. The finished size, the colour and the fibre are agreed for the commission and written into the specification. Where a design combines fibres, such as wool loop with lyocell, that combination is part of the agreement. If the project needs a different fibre, it is a new specification rather than a substitution inside the existing record.
The sample is the approval
Review the full design drawing, the detail, the light in the room, the furniture layout and a physical sample together. A sample shows the selected colour and local surface finish. Use the scaled drawing to judge the complete pattern and outline. Sign it off against the written specification so both documents describe the same object. Review a revised sample if colour or fibre changes afterwards.
Light and setting
Ask for the sample to be viewed in the room, under the lighting that will be in use, at the time of day the space is most used. Read the approved fibre and finish in raking light and under the actual light sources. Record which sample was approved under which conditions, so a later question about colour has a reference rather than a recollection.
Keep the approved set together
The approved drawing, the sample reference and the written specification form one set. They are the record for the piece, and they are what a later care question is answered against. Keep a copy with the project file and pass a copy to whoever maintains the space, along with the fibre and finish as recorded.
A brief you can send with the sample
If the piece is already intended as a handmade or hand-finished commission, use the commission brief for fibre, carving, samples and what handmade means. It sits alongside this specification guide and does not replace it. To choose a surface family first, use the carved pile, loop texture and sculptural surfaces decision table. To read the back and the edge against the written specification, use how to read the back and edge of a hand-finished rug.
